Oregon Concrete Contractor | Licensed Concrete Contractor Pros Serving Portland, OR

What's Covered

Concrete contractors in our network pour and finish new concrete for driveways, walkways, patios, garage floors, steps, curbs, and small foundations, and repair existing concrete — filling cracks, grinding trip hazards, releveling settled sections with mudjacking or slab jacking, and resurfacing worn surfaces. Every project includes a written estimate with clear scope, not a verbal number that changes once work starts.

New construction — driveways, patios, walkways, garage floors, and small foundation slabs poured to current code and properly prepared for Oregon's conditions.
Repair and restoration — crack filling, slab jacking to relevel settled sections, resurfacing worn or spalled surfaces, and edge repair.
Decorative work — stamped patterns, exposed aggregate, and stained finishes for driveways, patios, and walkways.
Commercial flatwork — parking areas, loading docks, ADA-compliant walkways, and equipment pads sized to actual load requirements.

Concrete Work in Portland Metro

Portland averages about 37 inches of precipitation a year at the airport station under NOAA's 1991-2020 climate normals, with downtown running higher — concrete drainage design is essential here. The wet climate also causes more frost heave and base erosion under slabs than in drier regions, making proper base preparation critical to long-lasting pours. Oregon's wet winters create specific challenges for concrete — proper drainage, correct mix design, and curing protocols matter more here than in drier climates. Contractors in our network schedule pours during appropriate weather windows and take the extra steps that make concrete last in the Pacific Northwest.

Weather-aware scheduling, since a pour started in the wrong conditions can compromise final strength regardless of mix quality.
Base preparation matched to local soil — clay-heavy valley soils need different handling than the volcanic or rocky ground found in Central and Eastern Oregon.
Drainage designed into the project from the start, not added as an afterthought once water starts pooling.
Curing protection appropriate to the season, since Oregon's rain doesn't pause for a fresh pour.

Is Your Concrete Showing These Problems?

Oregon's heavy rainfall, freeze-thaw cycles, and clay soils create specific conditions that damage concrete over time. Most problems are repairable if caught early — full replacement is often not necessary. Here is what to watch for:

Oregon-Specific Methods

Mix design, drainage planning, and curing protocols used by contractors in our network are suited to the Pacific Northwest — not imported from drier climates where different methods work.

Scope in Writing Before Work Starts

Every job includes a written estimate with clear scope — what's being done, what materials, and what it costs. No surprises on the final invoice.

Root Cause, Not Surface Fix

Concrete that keeps failing has an underlying problem. Addressing the cause — not just the surface — is what makes repairs and new pours last in Oregon's wet climate.

How to Verify a Provider's License

Oregon requires a state license for this trade through the Oregon Construction Contractors Board (CCB). Before hiring anyone, you can look up their license status directly with the state:

Verify a license with Oregon Construction Contractors Board (CCB) →

By state law, every licensed Oregon contractor's CCB number must appear on their advertising, including their website — a real provider should have no trouble giving you theirs.

concrete contractor Services in Portland

Concrete Work

Concrete contractor services for residential and commercial projects in Oregon.

Learn About Concrete Work →

Driveways

Concrete driveway installation and replacement in Oregon.

Learn About Driveways →

Concrete Repair

Concrete crack repair, leveling, and resurfacing for Oregon properties.

Learn About Concrete Repair →

Patios

Concrete patio installation for Oregon homes.

Learn About Patios →

Foundations & Flatwork

Concrete foundation flatwork, slabs, and structural concrete in Oregon.

Learn About Foundations & Flatwork →

Decorative Concrete

Stamped, stained, and decorative concrete for Oregon properties.

Learn About Decorative Concrete →

Walkways

Concrete walkway installation and repair for Oregon properties.

Learn About Walkways →

Commercial Work

Commercial concrete contractor for Oregon businesses and developments.

Learn About Commercial Work →

Areas Served

Concrete contractor service areas throughout Oregon.

Learn About Areas Served →

Warning Signs to Watch For

Many homeowners in Portland don't notice early warning signs until the problem has gotten worse. These are the signs worth paying attention to:

Cracks wider than a quarter-inch in driveway or patio
Sections that are sunken, settled, or creating trip hazards
Flaking or spalling on the surface after winter
Water pooling on the surface instead of draining away
Visible gaps or separation at control joints
Edges or corners that have crumbled or broken off

Learn More About Warning Signs

Not Sure If You Have a Problem?

If your concrete is showing any of these signs, call for an honest assessment. A contractor in our network will tell you whether repair is the right answer or whether full replacement makes more sense — and provide that assessment in writing.

Call (971) 443-1886

Serving Portland and surrounding Multnomah County.

Serving Portland and Surrounding Communities

Portland straddles the Willamette River where it joins the Columbia, and its neighborhoods reflect more than a century of growth around that confluence — Craftsman bungalows in older east-side neighborhoods like Hawthorne and Alberta sitting on lots with decades-old original driveways and walkways, and denser new construction filling in closer to the river as the city has grown. At roughly 37 inches of annual rainfall by NOAA's 1991-2020 normals, concentrated heavily in the fall-through-spring months, Portland's concrete work has to plan around genuinely wet pour windows more than almost any other major West Coast city, and the volcanic-influenced soils common in parts of the city hold moisture differently than the clay found further south in the Willamette Valley. Proper drainage design and base preparation matter here every time, not just on unusually wet years.

In addition to Portland, we regularly work in nearby areas throughout Multnomah County.

See full service area →

Frequently Asked Questions

How do I know if I need a concrete contractor or a handyman for my project?

Any project involving structural loads, drainage planning, or a permit — driveways, foundations, garage slabs — should go to a licensed concrete contractor. Small patch jobs on existing concrete can sometimes be handled by a general handyman, but if the repair fails it often costs more to fix than doing it right the first time.

How long does a typical concrete project take in Portland?

Most residential pours (driveways, patios, walkways) take one to three days from formwork to finish, plus curing time before the surface can handle full weight. Weather is the biggest variable in Portland Metro — we schedule pours around rain windows so the concrete cures properly rather than rushing it.

Do I need a permit for concrete work in Multnomah County?

It depends on the project. Driveways and patios usually do not require a permit, but foundation work, structural slabs, and anything attached to the house often does. We can tell you during the estimate whether your specific project needs one, and we work within the permitting process when it applies.

What makes concrete fail early in Oregon compared to drier states?

Water is the main culprit — rain that is not properly drained away from a slab, freeze-thaw cycling in winter, and moisture trapped under poorly prepared bases all accelerate cracking and spalling. Mix design and drainage planning suited to Portland Metro's climate matter more here than in states with less rainfall.

Get a Written Estimate Before Any Work Begins

Every project starts with a clear written estimate — what's being done, what materials are used, and what it costs. No surprises, no pressure.